Denon Soundbar Remote Control Codes

Denon Soundbar Remote Control Codes

Codes for Denon soundbar remote controls. You can control it with the universal remote control you have, a cable remote control, or a satellite remote control if you have a Denon soundbar. Almost any universal remote control can be used to control a Denon soundbar as long as you have the correct programming guide and the appropriate remote codes.

Also read: TaoTronics Soundbar Remote Control Codes

Denon Soundbar Remote Control Codes

The Denon Soundbar can be controlled with a universal remote. It is controlled by four and five-digit codes.

Denon Soundbar 4 Digit Remote Control Codes:











Denon Soundbar 5 Digit Remote Control Codes:










You can also search for these codes using the CAB or SAT remote…

Using Comcast Remote Control to search for Denon codes:

The Denon Soundbar must be turned on to be programmed.

Your remote control has a “Setup” button. Click that button and hold it. A green LED will appear.

 Use the number buttons to enter the remote code listed above.

This LED will blink green twice if the code has been accepted. A red blink indicates a wrong entry.

Control your Denon soundbar with the remote.

In case the code you entered was incorrect, try another code and repeat.

Also read: LG Soundbar Remote Control Codes

The DIRECTV remote control can be used to search for Denon codes:

Start Denon Soundbar by turning it on

The volume should be up, but muted

By pressing AV1 or AV2

For two blinks, hold down MUTE and SELECT

Wait two blinks after entering 9 9 1

You need to enter 3

Press release on VOLT UP

Keep pressing and releasing the CH UP key as you point the remote at the soundbar

Press SELECT to lock in the code when the volume changes.

This CODE SEARCH (Remote Control Programming) method was written for Comcast and DIRECTV remotes, however, you can use it on any universal remote. Following are examples of how to use your current remote to control your Denon soundbar using code search methods.

Using the same IR code as your TV, your Denon sound bar should be able to be programmed. Consult your sound bar’s manual. Here is the Denon DHT-S514 soundbar owner’s manual.

Denon’s DHT-S514, HEOS, and DHT-T100 soundbars should work with these remote codes.

Below are NEW DENON Soundbars including the DHT-S514…

Denon Soundbars

Are you having trouble programming your CAB SAT or Universal remote to your Denon soundbar? Let us know below if you need any assistance.

Leave a Reply

Your email address will not be published. Required fields are marked *