How To Program A COX Remote Control

How To Program A COX Remote Control

A remote control for COX can be programmed by following these instructions.

Also, read: How To Program A Sony Remote Control

Besides the Cable Converter, an RCA TV, a VCR, and a Pioneer audio receiver, the Cox Universal Remote Control can also be used to operate an RCA TV and a VCR. Following are the steps you need to follow to reprogram your remote to control devices other than the default brands…

  1. Turn on your device.

  2. Push one of the device keys once (like AUX, VCR, or CABLE) on your remote control. The selected mode key will flash twice when you press and hold SETUP. Release SETUP.

  3. To the right of the sidebar, enter the four-digit device code. A blinking mode key will appear if the code is entered correctly. Invalid codes are those that display long blinks when the mode key is selected. Try entering the code again after repeating steps 2 through 3.

  4. Press POWER on the remote control once you have aimed it at the device. You should see the device shutting down. Repeat steps 2-3 until you find one that works. If it doesn’t, use every code for your brand until you find one that does. Search for the code if you still can’t find it.

  5. Each device you want to control with the remote control requires repeating steps 1-4. Be sure to note down the codes for each device you wish to control. 

How To Program A COX Remote Control

Leave a Reply

Your email address will not be published.