Sceptre Soundbar Remote Control Codes

Sceptre Soundbar Remote Control Codes

We have the remote codes that will work with any Universal remote control, Cable remote, or SAT remote that connects to your Sceptre Soundbar. When you have a Sceptre soundbar’s programming guide and the remote codes for the soundbar, you can control it using any universal remote control. You must include the model number of your remote control and the model number of your soundbar in the comments box below. If none of the codes work, please provide the complete number of your remote control and the model number of your soundbar.

Also read: Remote Control Codes For Sceptre TVs

Sceptre Soundbar Remote Codes

Sceptre Soundbars can be controlled by universal remote controls.

The following 5 digit remote codes should be used.

Sceptre Soundbar 5 Digit Remote Control Codes:

10000

10878

11217

11360

11599

Trying the code search on the CAB or SAT remote may help if these remote codes do not work.

Code Search using Comcast Remote Control:

Soundbar should be turned on

Aux once by pressing Aux

When the setup key blinks twice, press and hold it

Setup of Releases

You can dial 9 9 1 3 or 9 9 3

Two blinks will be displayed on the Aux key

Aim the remote control at the soundbar and press Power

When the soundbar turns off, press CH+

A remote control in the code search mode will send IR codes from its library to the desired device.

Lock the code in by pressing Setup once

Two blinks will appear on the Aux key

Code Search using DIRECTV Remote Control:

Start the soundbar by turning it on

A volume that is muted but not too loud

By pressing AV1 or AV2

Hold down MUTE and SELECT for two blinks

Wait two blinks after entering 9 9 1

Please enter 3

Press release on Vol Up

Press and release the CH UP key while pointing the remote at the soundbar

You can lock in the code by pressing SELECT when the volume changes

These CODE SEARCH (Remote Control Programming) methods were written specifically for Comcast and DIRECTV remotes, but you can use them with ANY universal remote control. You can use the codes above to control your Sceptre soundbar with your current remote.

Having trouble programming your Universal or CAB SAT remote to your Sceptre soundbar? If you have any questions, please use the form below.

Related: SONY Soundbar Remote Control Codes

Leave a Reply

Your email address will not be published.